We recommend a competent person plan and carry out this installation. Please check the building plans for any underground pipes or cables.
Items to have in mind prior to installing:
The outdoor kiosk requires a power and data cable, please factor in a cable run prior to installation.
Be aware of the type of ground you are fixing into.
Please leave a 30mm distance from the base to any wall for access to the machine.
If you are installing a concrete base, the suggested size would be 1 meter x 1 meter.
The mounting surface needs to be levelled and uncracked concrete of a recommended minimum thickness of 250mm, and minimum quality C20/25. The suggested size would be 1 meter x 1 meter.
Drill hole for 6 Expansion-anchors (e.g. HILTI HSA)
Size: M8
Bolt length: 100mm
Depth of drill hole: 116mm.
The physical installation must be able to hold a pull of 2 tons and support a weight of 300kg.
The Base-frame can be used as a template to mark up and drill holes. Level the Base-frame if needed and fix it to the ground. The holes are slotted to enable some adjustment of position.
The below is meant as a guideline to plan the installation, for any physical installation requirements please contact a suitable engineer who will advise based on these details.
Outdoor measurements
Install fixing points
Position the outdoor kiosk in place and fix using the correct fixings for the type of material you have drilled into.
Suggested fixings are M8 x 100mm or 120mm.
There is a template below to show the fixing points, however, we would recommend waiting until you position the hardware in place.