This guide will help you get your Outdoor kiosk ready for extreme temperatures.
Before you start, power your kiosk down. Instructions are here.
Open the rear door of your kiosk with the keypad or your unique key.
Then remove the security plate, or open the inner door to access the lockers.
With the heater attached to the mounting plate, hold near the kiosk so you can route the cables before attaching the heater.
The Sensor wire is thinner and is to be located as shown, near the front of the kiosk, away from the heater.
The Power cable is thicker and should go down through the hole (see photo below) following existing wires (kiosk power cable and LAN cable) through the hole to the bottom of the kiosk.
Unscrew the metal cover as shown below to gain access to the inside of the
base where power and network cables are connected.
The power cable from the heater can plug in the power cable from the mains in the lower turret area. The same place the Network cable and Mains Power are connected.
The cables can be cable-tied to the connector as shown in red below to keep them
attached to the unit and accessible. Once they are connected and cable-tied, rotate the kiosk with the rear access panel open to ensure there is free movement. (Rotation of kiosk is not needed if the rear door can open fully in the final fixed position)
Once the power cables are connected, you can turn on the heater. Operating instructions are here. Once you have set the heater temperature, and tested it, you can mount the heater plate to the kiosk.
Install the heater mounting plate as shown. Beware that the fit is tight, ensure the bracket is installed in between the black beam and the lock bracket (green circle marking) and that the 4 holes align with holes in the black beam (red arrows).
Closer view of the black beam, locker bracket and the heater mounting bracket:
The bracket should now be secured by mounting the black back plate again reusing the screws. These 4 screws will now fasten both the bracket with heater and the back plate. If your kiosk has an inner door, not a back plate, attach the heater mounting bracket with screws.
