WARNING: BEFORE DOING ANY ELECTRICAL WORK, POWER THE KIOSK OFF & UNPLUG THE POWER CABLE
OVERVIEW: In the image below, we are removing the RED parts, and keeping the GREEN part.
Then, the wire from the Power/Network Plate will be re-routed directly into the Power Supply
INSTRUCTIONS:
Unlock the rear bottom door of the kiosk
Unscrew the two bolts holding the bottom cover plate. Then move the cover left and pull upwards to remove (this can be tricky)
Then unscrew these two nuts and take off the cover.
Make note (or take photo) of the wires on the right. You will need to reconnect these with the other cable later. When you have made note of these, loosen the 3 screws (in red circle) until you can release the 3 wires coming from the extension cable.
Unscrew these two nuts and loosen the brackets to take out the cream extension plug.
Disassemble the plug and remove the cable (there are 4 screws on back, plus 2 in the sockets)
Then loosening the screws (red circles) and you can pull the cable out of the extension body:
Now you can connect these three wires correctly to these connectors on the DC power supply (same wire colours as it was at step 4)
Replace the cover that you removed in step 3
Refit the bottom cover plate that was removed in step 2.
Job done! Plug in power cable and restart kiosk.
If you have any problems, please feel free to contact [email protected]